#Make ready for COVID

There’s a lot of buzz on the interweb about 3D-printing personal protective equipment (PPE) in light of the severe shortages across the country and especially close by to me. (I’m sure it has nothing to do with sending much of our supply to china last month.) I wanted to see how easy it was to actually do.

I’ve got my 3D printer, a Prusa MK2, up-and-running in my home office. I followed these instructions for making a mask and this design for the face shield. Both designs are reported to be printable without the use of supports or other fancy settings, so I loaded them on the build plate and off I went. After 5 hours of printing (3 for the mask, 2 for the shield) I ended up with this.

Green screen added for future special effects 🙂

I’m surprised at how well these designs printed with no modifications needed. I’ve got some temperature calibration to tweak because both designs have overhangs that printed poorly but only affected the aesthetics of the final object. Double sided tape worked just fine to keep the document transparency in place. I’m now ready to fight the coronavirus … or clean the litter box.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.